Category: aids for daily living

DIY Universal Utensil Holder

AbleData does not produce, distribute or sell any of the products listed on this website, but we provide you with information on how to contact manufacturers or distributors of these products. If you are interested in purchasing a product, you can find companies who sell it below.

---- DO IT YOURSELF ENTRY --------- PURPOSE: To create a do-it-yourself universal utensil holder to assist individuals with arthritis and grasping, fine motor or neuromuscular disabilities to hold and manipulate eating utensils. Step 1: Cut the pieces. Measure the hand—length and width—of the person the holder is for, using an average of 2 inch width depending on the size of the hand of the person. After cutting the rectangles out of the plastic package them both sides in duck tape. Step 2: Cut Slides. Make two cuts on one of the pieces for the rubber band that is going to hold it in place. On the other piece make a cut about an inch from the end, this is where the utensils will go in. Step 3: Install the rubber band. Put one side of the rubber band in one hole in a loop and hold with duct tape and repeat the same in the other side; now put both pieces together and close the around all the edges with duct tape. Step 4: Ready to Use! The holder can be used to insert almost any kind of utensil, even pens and markers. TOOLS: A plastic package that has a nice big flat surface, duck tape, rubber bands, scissors, a ruler, and a dremel. SKILLS REQUIRED: Basic craft ability. AUTHOR: nelson8815. TITLE: Assistive eating, universal utensil holder—almost for free. WEBSITE: Instructables. REF:


Price Check
as of: 
Additional Pricing Notes: 

Contact manufacturer

Diy Universal Utensil Holder